Worktop replacement in Torrent
Before ordering a new surface, check the reference of the sink bowl you want to keep. An external measurement does not describe the installation hole: the template, the type of support and the fixings are required. If these pieces are not identified, it is preferable to resolve this before cutting, especially when the joint will be visible below.
Tell us about your kitchen
Choose the type of renovation and the approximate size. Then write to us or fill out the form.
Supports, gaps and joints of the piece
- MeasurementUnderstand the measurements and where the piece rests.
- MaterialsCompare finishes thinking about daily use.
- DisassemblyPlan how the existing surface will be removed.
- SinkCheck the sink before cutting the piece.
- HobCheck gap and assembly.
- AuctionsDefine edges and tufts.
- InstallationPlace the new worktop.
- final finishCheck joints and seals.
Worktop replacement quote in Torrent
What appears when you lift the old surface
The retreat allows you to check the upper edges of the furniture and its supports. A swollen area or attachment that has yielded may need repair before assembly; covering it with the new part would leave the problem pending. When helmets are maintained, these adjustments should be separated from a possible renovation of the furniture, in order to distinguish the necessary work from the change you prefer. See also: furniture renovation.
The connection is also part of the replacement
Ask who disconnects the tap and drain and who checks them again after assembly. This distribution avoids receiving a finished worktop with the washing area still unusable. Plumbing and reconnection of the sink should be expressly included or excluded in the proposal, together with sealings and auctions. See also: plumbing and sink reconnection.
Quote and scope of work at Torrent
To evaluate the replacement we identify material and thickness, existing supports and preserved sink system. The scope must include withdrawal, gaps and seals, in addition to the disconnection and reconnection that the assembly requires when changing the surface.
